Description O2 Controller Lambda emulator The use of the new O2 controller allows the management of carburetion in the area where the Lambda probe controls the concentration of the air petrol mixture to be introduced into the combustion chamber. This device is able to make the lambda probe work at a value different from the stoichiometric one, enriching the A/F (Air/Fuel ratio) to improve torque and power while always respecting the DNA of the engine. It is the main objective of the Malossi research and development department to ensure that that for each vehicle corresponds to a calibration designed to optimize performance and consumption. Complete control of the carburetion, is obtained by combining the O2 controller with the Force Master control unit. The synergy of these two devices has no limits, the entire quoted plan is managed, controlled and optimised, for any stage of processing proposed by Malossi. The evolution that engine control systems have had over the last few years has led to the design of this new version. The emulation of the Lambda sensor signals is now perfectly corresponding to the original sensor, while the aesthetic appearance has been refined and has been enriched with an essential optical interface, which emulates the actual operation of the device. The Power LED allows you to verify the correct fuel supply, while the remaining two LEDs show the carburetion level. When the vehicle is turned on, the power LED and the Rich LED come on. After a warm up period of the probe, if you are in the closed loop control area of the Lambda, you will see the two Rich and Lean LEDs light up alternately. This type of behavior highlights the correct functioning of the device through continuous calibration of the A/F titre. Products reserved exclusively for competitions in places designated for them according to the provisions of the competent sporting authorities. We decline any responsibility for improper use