Audi 5 Cyl. X-Beam Steel connecting rods 144 x 20 mm BAR-TEK

5-cylinder X-Beam connecting rod for up to 1000 hp power output With our BAR-TEK X-Beam connecting rods for Audi 5-cylinder engines, you are ideally equipped for extreme performance increases: the 144 x 20 mm steel connecting rods can withstand up to 1000 HP , and the series connecting rods can no longer keep up. Our conrods are milled from the solid and with a weight of only 599 grams per conrod (including bolts) they are also very light . At the same time they are extremely stable due to their X-Beam. This is designed to distribute and reduce stress loads. The large cross-section of X-Beam rods ensures that they are crack-resistant and have high rigidity. These are the perfect characteristics of a connecting rod for ambitious drivers! The connecting rods for your Audi 5-cylinder come with an additional boring (rifle drilled), which provides much better piston pin lubrication . All connecting rods are precisely angled and tested by us. Included are ARP 2000 3/8" expansion bolts and the corresponding ARP assembly lubricant. Our special X-Beam steel connecting rods are perfect for all Audi 5-cylinder engines such as the S2, RS2 and all 2.3L 20V 7A engines with 144 x 20 mm connecting rods. Features of our x-beam connecting rods: Original BAR-TEK connecting rod with X-Beam milled from the solid and thus high-strength suitable for extreme performance increases up to approx. 1000 HP extremely light and very stable Magnaflux inspected 5 pieces per set Dimensions: 144 x 20 mm Weight per connecting rod with screws only 599 grams precisely angled and tested at our premises With ARP 2000 3/8" expansion bolts ARP assembly paste With additional drilling for piston pin lubrication (Rifle drilled) Tighten your connecting rods correctly The connecting rods come with screws and assembly paste, so you have everything you need for assembly. However, there are a few important things to keep in mind. On this page we have summarized for you how to mount and tighten connecting rod screws correctly. The bearings are not included in the scope of delivery. More information on how to properly tighten the connecting rod bolts Manufacturer Information about the manufacturer BAR-TEK BAR-TEK Motorsport GmbH Im Rauschen Auel 3, 51491 Overath-Brombach, Germany info@bar-tek.com